Mighty Mite Anchors 888 868-0238
The Mighty Mite anchor tine is a mallable and designed to bend out
and release from structure when the right pressure is applied. Normally
only one or two tines will bend to release.
The tine or hook can be reshaped to use over and over again. Put the
tine on a hard surface and use the shaft of the anchor to apply slow
pressure. It will bend back into shape easily.
and release from structure when the right pressure is applied. Normally
only one or two tines will bend to release.
The tine or hook can be reshaped to use over and over again. Put the
tine on a hard surface and use the shaft of the anchor to apply slow
pressure. It will bend back into shape easily.
How to release a stuck anchor: Pull the slack line from the anchor rope. Put boat directly above the
anchor and tie rope off or cleat to bow. REVERSE engine slowly and the anchor should bend out. NEVER
GO FORWARD TO DISLODGE the anchor.
A Mighty Mite is designed to bend free most of time and will come loose more often than fluke or shovel
anchors. However, there circumstances that it will not. If you have tried to free it and can't, it's best to cut
the rope.
anchor and tie rope off or cleat to bow. REVERSE engine slowly and the anchor should bend out. NEVER
GO FORWARD TO DISLODGE the anchor.
A Mighty Mite is designed to bend free most of time and will come loose more often than fluke or shovel
anchors. However, there circumstances that it will not. If you have tried to free it and can't, it's best to cut
the rope.
Click on Prokontroll to check out
great products for your trolling motor.
great products for your trolling motor.
 | |  | |  | |  | |  | |  |
HOW TO